msms Posted October 14, 2003 Share Posted October 14, 2003 On Belinea 101556 I can see only 2/3 of picture. 1/3 of picture is under screen. Auto doesnt repair it. How is possible set whole picture to screen ? Quote Link to comment Share on other sites More sharing options...
Atomic Mitten Posted October 14, 2003 Share Posted October 14, 2003 You should post this in the Technical support section. ;)Have you tried switching your monitor off and back on again after a few minutes ?It sounds like a vertical sync problem.Also check that the connection to your graphics card is secure and not come loose.Try re-installing your monitors drivers. :) Quote Link to comment Share on other sites More sharing options...
msms Posted October 14, 2003 Author Share Posted October 14, 2003 when I see on info from LCD panel - it displaying 640 x 350 ???( I tryed dune2000 -g too. Then picture is verticaly OK, but horizontaly is moved now. ) Where is technical support ? On www.westwood.com is notning about duna2k yet :-((( Quote Link to comment Share on other sites More sharing options...
Andrew Posted October 14, 2003 Share Posted October 14, 2003 No, Tech support is on Fed2k.http://www.dune2k.com/forum/?board=4 Quote Link to comment Share on other sites More sharing options...
Pawe Posted November 24, 2003 Share Posted November 24, 2003 Wierd... In our house there are two TFT monitors; Samtron 51s and Hyundai Q15S and D2k runs without any problems on those... Quote Link to comment Share on other sites More sharing options...
kopeee Posted December 29, 2003 Share Posted December 29, 2003 in my home are two difirent monitor one of them are lcd 15 and this monitor also was this problem... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.